- sag: a shape that sags; "there was a sag in the chair seat"
- sag: droop, sink, or settle from or as if from pressure or loss of tautness
- hang loosely or laxly; "His tongue lolled"
- wilt: become limp; "The flowers wilted"
- (drooping) weak from exhaustion
- (drooping) cernuous: having branches or flower heads that bend downward; "nodding daffodils"; "the pendulous branches of a weeping willow"; "lilacs with drooping panicles of fragrant flowers"
- A proportional–integral–derivative controller (PID controller) is a generic control loop feedback mechanism (controller) widely used in industrial control systems – a PID is the most commonly used feedback controller. ...
- Droop is the phenomenon that efficiency of a light-emitting diode tends to decrease for increasing current.
- (Drooping) Alcohol intoxication (also known as drunkenness or being drunk or inebriated) is a physiological state occurring when an organism has a high level of ethanol in its bloodstream, or when ethanol otherwise causes the physiological effect known as drunkenness. ...
- something which is limp or sagging; a condition or posture of drooping; To sink or hang downward; to sag; To slowly become limp; to bend gradually; To lose all enthusiasm or happiness
- (drooping) An instance of something drooping; That droops or droop
- A sustained deviation between the control point and the setpoint in a two-position control system caused by a change in the heating or cooling load.
- A governor/ system characteristic, usually adjustable, which matches the change in load to changes in machine speed/system frequency.
- A common occurrence in time-proportional controllers. It refers to the difference in temperature between the set point and where the system temperature actually stabilizes due to the timeproportioning action of the controller.
- is used when you are referring to a slope with respect to time. Let's put this in a practice sentence...
- The decrease in outlet pressure of a gas pressure regulator which results from an increase in flow rate. Essentially the reverse of lockup (also see "LOCKUP").
- Smooth projection of the double seam outside and below the bottom of the normal seam. Usually occurs at the side seam lap area.
- A monotonic decrease in passband gain with frequency. If present, it typically is included in the gain or ripple specification. See Gain Error and Passband Ripple.