Online Google Dictionary

blistering 中文解釋 wordnet sense Collocation Usage Collins Definition
Adjective
/ˈblistəriNG/,
Font size:

(of heat) Intense,
  1. (of heat) Intense
    • - the blistering heat of the desert
  2. (of criticism) Expressed with great vehemence
    • - blistering diatribes
  3. Extremely fast, forceful, or impressive
    • - Burke set a blistering pace
  1. acerb: harsh or corrosive in tone; "an acerbic tone piercing otherwise flowery prose"; "a barrage of acid comments"; "her acrid remarks make her many enemies"; "bitter words"; "blistering criticism"; "caustic jokes about political assassination, talk-show hosts and medical ethics"; "a sulfurous ...
  2. vesiculation: the formation of vesicles in or beneath the skin
  3. hot enough to raise (or as if to raise) blisters; "blistering sun"
  4. very fast; capable of quick response and great speed; "a hot sports car"; "a blistering pace"; "got off to a hot start"; "in hot pursuit"; "a red-hot line drive"
  5. Blistering, founded in 1998, is an international online magazine dedicated to heavy metal and hard rock music. Its editor-in-chief is David E. Gehlke, an American music journalist who has written for About.com, Metal Maniacs, and Throat Culture. ...
  6. (Blisters) A blister is a small pocket of fluid within the upper layers of the skin, typically caused by forceful rubbing (friction), burning, freezing, chemical exposure or infection. Most blisters are filled with a clear fluid called serum or plasmahttp://www.ncbi.nlm.nih.gov/pubmed/3358612? ...
  7. (Blistered) To pull off a bit of an Oliver McCrevice while pig dogging backside in an inverted tunnel/tube.
  8. (blistered) Where the surface of an organ is puckered, the veins being tighter allowing the tissue to round up.
  9. (Blisters) A raised spot or bubble on the surface or a separation between layers, usually forming a void or air-filled space in the vulcanized article.
  10. (Blisters) Bubbles that may appear on the surface of asphalt roofing after installation.
  11. (BLISTERS) Soft raised or puffed spots appearing on siding where paint was improperly applied. Also may be seen on roof covering that was improperly installed.
  12. (Blisters) A nickname for a lazy person, ie. appears after the work is done. Also short for blood blisters - rhyming slang for sisters
  13. (Blisters) Water-soluble, powdery crystals on the surface, generally white, can be brushed off. Caused by too much water in a plaster mix, over troweling, or too dry a base or brown coat.
  14. (blisters) (in  blister (dermatology))
  15. Unsightly blisters on paint are generally caused by putting new paint upon the top of old, or using very thick paint. The old paint should be burnt or scraped off.
  16. Bubbles or pimples in roofing materials. Usually moisture related. In shingles blisters are either moisture under the material or moisture trapped inside the material.
  17. The formulation of dome-shaped, hollow projections on paint, often caused by heat or moisture. Can also be caused by solvent entrapment in a paint film which has surface dried before the solvent has completely escaped.
  18. The end result of poor adhesion by either paint or vinyl to a substrate, leaving the surface covered with bumps of various sizes and indeterminate shapes similar to blisters on the human skin.
  19. Formation of dome-shaped projections in paints or varnish films resulting from local loss of adhesion and lifting of the film from the underlying surface.
  20. Although seemingly dry, paper does contain approximately 5% moisture. In cases where there is excessive moisture, and the paper is passed through a high heat-drying chamber, the moisture within the paper actually boils and causes a bubble or blistering effect.
  21. The formation of blisters in toppings or coatings and the loss of adhesion with the underlying substrate. On concrete surfaces, this is often caused by moisture or moisture vapor transmission problems.
  22. A paint failure often caused by moisture in the wood breaking the bond between the paint and the wood.
  23. A raised or layered patch of material on the surface of the component.
  24. The consequence of a tire, or part of a tire, overheating. Excess heat can cause rubber to soften and break away in chunks from the body of the tire. ...
  25. Swelling caused by the expansion of gas inside a material while it is still soft or liquid due to heat. Can occur on painted surfaces of materials when heated.